Denon AVR-X8500H User Manual

Setting the Remote ID
When using multiple Denon AV receivers in the same room, make this
setting so that only the desired AV receiver operates.
0
The default setting is “ID-1”.
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “RC-ID” on the remote control unit
and press ENTER.
3
Use ui to set the remote ID and press ENTER.
“OK” flashes four times on the remote control unit and the normal
operation mode is restored.
Remote control unit display Remote ID
ID-1 1
ID-2 2
ID-3 3
ID-4 4
NOTE
0
When you change the remote ID, make sure that the remote control unit and the
remote ID of the main unit are exactly the same. (v
p. 266)
Setting the display time length of the
remote control unit display
Use the following procedure to set the length of time for which to display
data such as zone and mode on the display panel of the remote control
unit.
0
The default setting is “05SEC”.
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “DISPL” on the remote control unit
and press ENTER.
3
Use ui to set the display time length and press
ENTER.
“OK” flashes four times on the remote control unit and the normal
operation mode is restored.
Remote control unit display Display time
05SEC 5 sec
10SEC 10 sec
15SEC 15 sec
Contents Connections Playback Settings Tips Appendix
284
Front panel Display Rear panel Remote Index

Denon AVR-X8500H Specifications

General

Channels	13.2
Power Output	150W per channel (8 ohms, 20Hz-20kHz, 0.05% THD)
Frequency Response	10Hz-100kHz (+1, -3dB)
HDMI Inputs	8 (1 front)
HDMI Outputs	3
Dolby Atmos	Yes
DTS:X	Yes
IMAX Enhanced	Yes
HEOS Multi-room	Yes
Wi-Fi	Yes
Bluetooth	Yes
Voice Control	Amazon Alexa, Google Assistant, Apple Siri
Impedance	4-16 ohms
HDR Compatibility	HDR10, Dolby Vision, HLG
Audio Return Channel (ARC)	Yes
Digital Audio Inputs	2 Optical, 2 Coaxial
Analog Audio Inputs	6
Phono Input	Yes
Speaker Connectors	Binding Posts
Supported Audio Formats	MP3, WMA, AAC, FLAC, ALAC, WAV, DSD
Surround Sound Support	Dolby Atmos, DTS:X, Auro-3D
Tuner	AM/FM
Input Sensitivity/Impedance	200 mV / 47 kohms
HDCP Support	2.2
Other Connections	USB, Ethernet, RS-232C
Wireless Connectivity	Wi-Fi, Bluetooth
Signal-to-Noise Ratio	102 dB
DAC	AKM AK4490EQ (32-bit/192kHz)
Total Harmonic Distortion	0.05% (20Hz - 20kHz, 150W)