o
Inputs of this unit cannot be switched with the HDMI control (CEC) function
0
Check whether the HDMI CONTROL switch on the side panel of this unit is turned ON.
0
Check whether the HDMI control function settings are enabled for all devices connected to this unit. In the settings for the connected source devices, if
there are settings to link to and turn on other devices when the power is turned on, enable those settings as well.
0
The specifications for HDMI control vary by device. If the source device has an auto standby function, it is recommended to enable the auto standby
function so that the power turns off automatically when not in use.
0
When you make connection related changes such as connecting an additional HDMI device, the link operation settings may be initialized. Turn off this
unit and devices connected via HDMI, and turn them on again.
0
Depending on the connected devices and settings, the HDMI control function may not work. If the problem is not fixed even after confirming the above,
use the remote control unit to change the inputs for this unit directly.
o
The inputs for this unit change when this unit receives the signals of the remote control supplied
with the AV receiver/AV amplifier
0
The AVR CONTROL switch on the side panel of this unit is turned ON. If you do not want to use it, turn the switch OFF.
Contents
Connections Operations Troubleshooting Appendix Specifications
22
Front panel Rear panel Side panel Remote
To Next Page
Loading...