Denon DHT-S216 - Disassembly

o
Using the remote control learning function
1
Press and hold the main unit’s d for 3 seconds until
the status display LEDs flash in white for one complete
cycle.
2
Point the remote control of this unit at the remote
sensor of this unit and press the remote control button
to be learned (e.g. VOL +) once.
All status display LEDs blink in white.
.
Approx. 30 cm
3
Point the remote control of the TV at the remote control
sensor of this unit and press the remote control button
to be learned (e.g. the button to increase the volume)
once.
If learning is successful, the rightmost status display LED blinks in
blue three times.
If learning is unsuccessful, the rightmost status display LED blinks in
red three times. Repeat steps 2 and 3 if this happens.
0
When the status LEDs blink in white again, press the TV remote control
button (e.g. the button to increase the volume) once more.
4
To learn a new function, repeat steps 2 and 3 with the
next function.
5
Press and hold the main unit’s d for 3 seconds until
the rightmost status LED blinks in white three times.
The unit exits remote control learning mode.
6
Confirm that the operation (e.g. increasing the volume)
can be performed on this unit with the TV remote
control.
Contents Connections Playback Settings Tips Appendix
29