Auto standby function
If no operations have been performed for 15 minutes or more and audio is
not being output, this device automatically switches to standby.
1
Press and hold NIGHT for 5 seconds or more until the
status display LEDs blink as indicated below.
.
Off
On
(Default)
Auto
standby
function
Volume limiter function
When the power of this unit is turned on, the volume is the same volume
that was set before the unit was placed on standby. When this function is
enabled, the volume is lowered to a normal level if a high volume was
used before the unit was placed on standby.
Operating this unit using the remote
control of a TV
There are two ways to operate this unit using the remote control of a TV.
0
HDMI control function
Connect this unit to a TV that supports the HDMI control function with
an HDMI cable and enable the HDMI control setting on the TV to
perform basic operations on this unit (changing the input source, turning
the power on and off, adjusting the volume) with the remote control of
the TV.
Refer to “HDMI control function” for more information about the HDMI
control function. (v p. 36)
0
Remote control learning function
If your TV does not support the HDMI control function, use this unit’s
remote control learning function. This enables you to operate this unit
with the remote control of a TV. (“Using the remote control learning
function” (v p. 29))
Contents
Connections Playback Settings Tips Appendix
28
To Next Page
Loading...
