Why is my Denon Tape Deck not running?
Your Denon Tape Deck might not be running due to several reasons: * The power cord may be off. Check the power cord. * The tape might be completely wound up. Rewind the tape. * The tape could be loose. Tighten the tape with a pencil. * The cassette might not be loaded properly. Load the cassette correctly. * The cassette itself could be defective. Replace the cassette.
General| Track System | 4-track, 2-channel stereo |
|---|---|
| Total Harmonic Distortion | 1.0% |
| Tape Selector | Normal, CrO2, Metal |
| Frequency Response | 20 Hz - 20 kHz |
| Wow and Flutter | 0.08% (WRMS) |
| Noise Reduction | Dolby B |
| Input | Line: 77.5mV |
Procedure for safely removing the cassette compartment cover for easier access during maintenance.
Instructions for cleaning the pinchroller and capstan to ensure proper tape transport and prevent damage.
Guidance on cleaning the tape heads to maintain sound quality and prevent deterioration.
Steps for demagnetizing tape heads to prevent noise and loss of high-frequency response.
Detailed circuit diagram for the wired remote control box connection.
Guidelines for operating multiple DN-720R units simultaneously using the wired remote.
To Next Page
