Denon DNP-2000NE - Page 82

Audio
Make audio-related settings.
Line Out Level
Set according to the terminal (VARIABLE or FIXED) where the amplifier is
connected. Use this setting when connecting a Denon amplifier to this unit
using IR control. (v p. 29)
Variable
(Default):
When the “Power On Link” function is used,
the input source of the Denon amplifier
switches to “EXT.PRE.” Control the volume
of the audio signal output from this unit’s
analog audio output terminals (VARIABLE)
with the HEOS app or TV remote control
unit (HDMI control function).
Fixed:
When the “Power On Link” function is used,
the input source of the Denon amplifier
switches to “NETWORK.” Control the
volume of the Denon amplifier connected to
this unit with the HEOS app or TV remote
control unit (HDMI control function).
Volume Limit
Make a setting for the maximum volume of the audio signal output from the
analog audio output terminals (VARIABLE).
Off
(Default):
Do not set a maximum volume. (100
(+6dB))
95 (+1dB) / 90 (-4dB) / 85 (-9dB) / 80 (-14dB)
Contents Connections Playback Settings Tips Appendix
82
Front panel Rear panel
Remote control
unit
Index