Denon DRM-400 - Playback and Recording Procedures; Playback Operation Steps

PLAYBACK
¢ Switch on your amplifier or receiver.
eSet the TAPE MONITOR switch on your amplifier or receiver to the TAPE position.
© Operate the deck in numerical order as illustrated below:
2) eo. e
e
2
3]
4)
e
PHONES
Playback sound is fed into the headphone set.
POWER
Push the switch to turn “ON’’ (a=) the power.
EJECT
;
Press
the
EJECT
button
to
open
the
cassette
compart-
ment.
.
;
Cassette Compartment Cover
Load the cassette tape.
DOLBY NR
For recordings made without Dolby NR, set to “OFF’’.
For recordings made with Dolby B NR, set to “‘B’’.
(The B-NR indicator will ‘light up.) .
For recordings made with Dolby C NR, Set to “‘C’’.
(The C-NR indicator, will light up.)
RECORDING
* Switch on the source component (tuner, amplifier, etc.).
«Set the TAPE MONITOR switch on your amplifier or receiver to the SOURCE position.
e .3 12]
@ PLAY
Push the PLAY button.
e When playback is finished, press the stop (g@ STOP) button.
eTo restart the tape, press the PLAY (®PLAY) button.
elf different types of Dolby Noise Reduction are used for
record and playback, playback response will be adversely
effected.
Note:
If the power switch is turned OFF in either the re-
cording or playback mode, the cassette cannot be
removed, even if:the EJECT button is pressed.
Please turn the power. switch ON again, and then
in stop mode, press the EJECT button to remove
the cassette tape.
FULL LOGIC CONTROL 7 BIAS ADJUST SYSTEM