Advanced speaker settings
Caution
0
Adjusting these settings may disconnect your speaker from your
network and possibly render your speaker unusable. Do not use these
features unless you are comfortable making advanced adjustments to
your speaker.
o
Network settings
1
Select “Advanced”.
2
Select “NETWORK SETTINGS” tab.
3
Scroll down to see all of the options for
a. Network Interface (Ethernet or Wireless)
b. Wireless Settings
c. IP Address Settings (Automatic or Manual)
d. Wireless Power Saving
4
Select “Save Settings” to apply the new settings or
“Cancel Changes” to revert to the previous settings.
o
About wireless power saving
The Wireless Power Savings feature saves power by turning off power
to the wireless radio inside the HEOS device when the device is
connected to an Ethernet network. If you disconnect the Ethernet
cable from the HEOS device, Wireless Power Saving will
automatically turn off and the wireless radio will turn on so that the
HEOS device can be discovered over your wireless network.
NOTE
0
If Wireless Power Savings is ON, Wi-Fi power will be temporarily turned on when
accessing the My Devices - (My Devices) - Network screen in the HEOS app or
whenever the Connect button on the device is pressed.
Contents Setup Use Troubleshooting Status LED Appendix
40
To Next Page
Loading...
