Denon MC2000 Quick Start Guide

VERSION 1.1
DJ-FX
The DJ-FX in Serato DJ are powered by iZotope™. Click the FX tab
to open the FX panel. Select either 1, 2 or M to assign the selected effect bank to a
deck or Master Output. To activate an effect, click the ON button on your FX UNIT
in the software, or the left most button in either FX1 or FX2 areas of your controller.
You can adjust effect parameters by using either software controls, or the knobs/
buttons in the FX1 and FX2 section on your controller.
There are two available modes in the DJ-FX. Single FX Mode allows you to select
one effect per FX bank, and has multiple parameters that can be adjusted. Multi
FX Mode allows you to select up to three effects per FX bank, and adjust only
one parameter, the FX Depth. The same effects available in Single FX mode are
available in Multi FX mode, as well some additional presets.
You can select between the two FX modes by clicking either the Single FX mode
button or Multi FX mode button
MC 2000 Control Single FX Mode Shift
FX Knob 1 Adjust Parameter 1
FX Knob 2 Adjust Parameter 3
FX Knob 3 Adjust Parameter 5
FX button 1 Effect On/Off Select Effect
FX Button 2 Adjust Parameter 2
FX Button 3 Adjust Parameter 4
MC 2000 Control Multi FX Mode Shift
FX Knob 1 Adjust Slot 1 Parameter
FX Knob 2 Adjust Slot 2 Parameter
FX Knob 3 Adjust Slot 3 Parameter
FX Button 1 Slot 1 On/Off Select Effect in Slot 1
FX Button 2 Slot 2 On/Off Select Effect in Slot 2
FX Button 3 Slot 3 On/Off Select Effect in Slot 3
The effect time is set using the tracks BPM value, but by applying the Beats
Multiplier you can increase or decrease the effect timing. Modify this by using the
BEATS knob on the controller. Automatic tempo requires that the track on the deck
assigned to the FX Unit has BPM information. Manual tempo mode allows you to
tap in the tempo yourself.
Note: To change to Manual Tempo mode, simply tap the BEATS knob until a
desired rate is established. To return to AUTO mode, click and hold the BEATS for
1 second.
MC2000 Control Serato DJ Function
BEATS press for 1 second Auto Tempo Mode
Tap down the BEATS to the desired rate Tap
Turn BEATS knob Beats Dial

Denon MC2000 Specifications

General

Brand	Denon
Model	MC2000
Type	DJ Controller
Channels	2
Crossfader	Yes
Software	Serato DJ Intro
MIDI	Yes
Inputs	1/4"
Outputs	RCA, 1/4"
Audio Interface	Yes
Software Compatibility	Serato DJ, Virtual DJ