Denon PMA-500V - Page 11

ENGLISH ne
Speaker system (A)
Speaker system (B)
e@ Connection to the speaker system
L
Connect
the
speaker
system
for
the
left
channel
{the
left
side
as
viewed
facing
the
front)
to
the
L
speaker
terminal
on
the
back
panel,
and
the
speak-
er
system
for
the
right
channel
into
the
FR
ter-
minal.
There
are
two
sets
of
SPEAKERS
ter-
minals.
1f
only
one
speaker
system
is
to
be
used,
connect
it
to
the
SYSTEM
A
terminalis.
@ AC OUTLETS. .. For U.S.A., Canada and Asia
AC outlets are used for connecting amplifier component units, jh as Sune: turntable,
tape deck, etc,
@ SWITCHED (Capacity: 100 W):
This outlet is turned on/off when main power swirch is turned on/off.
@ UNSWITCHED (Total capacity: 250 W}
These outlets are always ON whetehr power switch is on or
off,
@ LINE VOLTAGE (Voltage select switch) ... For Asia model :
only. PRE-SET
* The desired voltage may be set with the VOLTAGE as 8
SELECTOR KNOB on the back panel using a screw driver.
* Do not twist the VOLTAGE SELECTOR KNOB with exces-
sive force. it may be damaged.
If the voltage select switch does not turn smoothly, see a quali- :
fied serviceman.
A+ B= 12-16 ohm
cy
=|
p—d)
Re Line voltage wali outlet
@ Notes on Connection
Do not plug the power supply cord into the wall socket, until all the
connections are complete.
Verify which channel is the left and which is the right, and then plug L
into L and R into R.
Plug the pins in securely. An iyconiplate connection will cause noise
generation,
Do not use the AC OUTLETS terminals to provide power for a hair
drier or other electrical appliance after the power supply cords of the
audio components have been plugged in.
Binding the pin plug to the power supply cord,-or setting the pin cord
close to the power supply transformer will cause humming or noise, and
should be avoided.
The PHONO input terminal is extremely sensitive. Avoid using the amp :
when the pin cord is not plugged into the terminal. If the pin cord is a
HEHE HH PHASE
® vee © ono soon © O
not used, a low humming may be emitted from the speaker when the
)
Graphic
equalizer
or
amp
is
on.
various audio processors
When
this
termina!
is
not
being
used,
OUT
and
IN
should
be
connected
with
the
Jumper
Pin.