Denon PMA-500V - Page 12

ene enero
ENGLISH
@ Connection to the speaker system
@
When
connecting
the
speaker
terminals
to
the
speaker
systems,
make
certain
to
connect
the
polarities
.
correctly
(+
to
+
and
—
to
—).
If
the
polarities
are
incorrect
when
the
two
are
connected,
the
center
area
of
the
sound
will
be
lacking,
the
positions
of
the
musical
instruments
will
not
be
clear,
and
the
stereo directional sensitivity will be impaired.
®
During
connection,
be
careful
that
the
center
wires
in
the
speaker
cords
do
not
protrude
from
the
terminals
to
contact
any
other
terminal,
and
that
the
central
wires
in
the
separate
speaker
cords
do
not contact each other.
@ Speaker impedance
@ When the A and B terminal sets are to be used separately, the speakers that are to be connected
should have a nominal impedance of 6 to 16 ohms.
:
@
When
the
two
sets
(A
+
B)
are
to
be
used
at
the
same
time,
use
of
speakers:
whose
impedance
is
;
outside
the
range
from
12
to
16
ohms
will
result
in
malfunction.
Be
careful
not
to
let
this
happen.
@ Speakers with a lower impedance may cause the protective circuitry to operate.
. Remove the insulation from the end of each cord.
ES . Twist the center wire. 7 @
. Turn the speaker terminal to loosen it, insert the center wire
| of the cord, and then tighten the terminal to hold the wire
in place.
® Connecting the Record player
@ Connect the record player output cord to
the PHONO terminal on the amp unit, with
the L plug in the L terminal and the R plug
in the R terminal. °
If the player has a ground wire, connect it to
the GND terminal.
* If humming or other noise is scene when
the ground wire is connected, do not con-
nect it.
Record player
PMA-500 V
® Connecting the CD Player
® Connect the output terminals of the CD
player (OUTPUT) to the CD terminals on Fe
the amp, using a pin cord,
Ert+1_ 9°
CD player
OUTPUT
CD player
49s