Denon PMA-500V - Troubleshooting Common Denon PMA-500 V Issues

TROUBLE-SHOOTING
If you think the amplifier is out of order, first check the following one more time:
1. Are all the connections correctly made? ;
i 2. Is the amplifier being operated properly in accordance with the Operating Manual? —
3. Are the speakers and player being operated correctly?
If the set does not operate properly, perform the checks indicated in the chart below. 1
saan epRsststennncie ScneLiOAL TR opacorréreininaets dn tisacnzer gent nMemtonU sanesreninthyatcongr tare me
If none of the items listed apply to the difficulty, the amplifier is probably out of order. Turn off the
power immediately, and contact the outlet where you purchased the amplifier.
Occurs During Record and Tape Playback, FM Reception, etc.
When the power switch is
turned on, the LED does
not light and there is no
sound.
The LED lights but there
is no sound from the speak-
ers.
Sound comes out from only
one side.
The volume differs for broad-
casting and record playback.
In stereo, the position of the
instruments varies to the left
and right.
The plug on the power
supply cord is not com-
pletely plugged in.
The speaker cords are not
fully connected.
The speaker switch is
OFF.
The tape monitor switch is
set to Tape-1 or Tape-2.
The setting of the INPUT
SELECTOR knob is not
correct.
The volume knob is set
too low.
The speaker cords are not
fully connected.
The input cord is not fully
connected,
The left/right balance is
off.
The tuner and the record
output differ.
The left and right speakers
or the left and right input
connection cords are re-
versed.
ies
@ Check whether the power
supply cord is plugged in
properly.
@ Connect them firmly.
® Turn the speaker switch to
Aor B.
®@ To listen to anything other
than a tape (REC, PB),
turn the MONITOR knob
to Source.
@ Select the appropriate set-
ting. :
® Turn the volume knob to
a suitable level.
e@ Plug the speaker cord in
firmly.
@ Plug the input cord in
firmly.
@ Turn the balance knob to
adjust the balance pro-
perly.
@ Adjust the tuner output to
correspond to the player
output.
Check the left and right
connections.