n
o
"
"
'"
~
o'
"
II>
~
:l"
~
."
C
"
~
o'
"
'"
""C
iii
-<
c:r
'"
n
",.
::;l
o
l:
c:r
iii
II>
:l"
o
~
:;'
«l
(j)
'"
::I
:;'
«l
~
:l"
'"
-i
3'
~
(j)
~
l:
"
(j)
"
'"
n
::;;
n'
~
0'
"
II>
Do
not wipe with a circular
motion.
CV
Load
the
two
batteries properly
as
indicated by the marks
in
the
battery compartment.
Gently wipe the disc from the
inside towards the outside.
~
About the Remote Control Unit
ENGLISH
Whl['lI-
Do
not use record
spray,
antistatic agents, or benzene, thinner or other
solvents,
• If there
are
fingerprints or dirt
on
discs, wipe them off before using
the disc. Fingerprints
and
dirt
can
impair sound quality
and
cause
interruptions
in
playback.
• Use a commercially available disc cleaning set or a soft cloth to clean
discs.
CD
Slide the rear lid
in
the
direction of the arrow
and
remove it.
@ Put the rear cover
back
on.
whlr'lI-
Do
not push the disc tray
in
by
hand when the power
is
turned off.
Doing
so
could damage the set.
o
"OOTr
00:
00"
is
displayed if a disc that cannot
be
played
is
loaded,
o
"OOTr
00:
00"
is
displayed if the disc
is
loaded upside-down or if
no
disc
is
loaded.
o Only load one disc at a time. Loading
two
or more discs
can
damage
the unit or scratch the discs.
o
Do
not use cracked or warped discs or discs that
have
been repaired
with adhesive, etc.
o
Do
not use discs
on
which the sticky part of cellophane tape or labels
is
exposed or
on
which there are traces of where labels
have
been
removed.
Such
discs
can
get caught inside the player
and
damage
it.
•
Be
sure to remove discs after using them.
•
Be
sure to store discs
in
their cases to protect them from dust.
scratches, warping, etc.
•
Do
not store discs
in
the following places:
1.
Places exposed to direct sunlight for long periods
of
time
2.
Dusty or humid places
3.
Places exposed to heat from heating appliances, etc.
o Do not get fingerprints, oil or dirt
on
discs.
o
Take
special care not to scratch discs when removing them from
their cases.
o
Do
not bend or heat discs.
•
Do
not enlarge the hole at the center.
•
Do
not write
on
the labeled (printed) surface with ball-point pens,
pencils, etc., or stick
new
labels
on
discs.
• Water droplets may form
on
discs if they
are
moved suddenly from a
cold place (outdoors for example) to a warm place, but do not
try
to
dry them off using a hairdryer, etc.
•
Do
not touch the signal surface.
~
o Place 8 cm discs
in
the inner tray guide without using
an
adapter.
WU')IW
o Discs with special shapes (heart-shaped discs, octagonal discs, etc.)
cannot
be
played.
Do
not attempt to play them,
as
doing
so
can
damage the product.
o Some discs
and
some recording
formats may not
be
playable.
~
>£)
o Non-finalized discs cannot
be
played. _ _
*What
is
finalization?
-.;:.;:-
-::=
Finalization
is
the process that
makes recorded CD-R/CD-RW discs playable
on
compatible
players.
o Set the disc with the labeled side facing
up.
o Make sure the disc tray
is
fully open when inserting the disc.
o
Place
the discs flatly,
12
cm discs
in
the outer tray guide (Figure
1),
8
cm discs
in
the inner tray guide (Figure
2).
Figure 1 I ,..Figure 2
3
Do
not wipe with a circular
motion.
@
Load
the
two
batteries properly
as
indicated by the marks
in
the
battery compartment.
Gently wipe the disc from the
inside towards the outside.
About the Remote Control Unit
'Cleaning
Discs
ENGLISH
• If there
are
fingerprints or dirt
on
discs, wipe them off before using
the disc. Fingerprints
and
dirt
can
impair sound quality
and
cause
interruptions
in
playback.
• Use a commercially available disc cleaning set or a soft cloth to clean
discs.
@ Put the rear cover
back
on.
CD
Slide the rear lid
in
the
direction of the arrow and
remove it.
.~[.u.
Do
not use record
spray,
antistatic agents, or benzene, thinner or other
solvents.
I@(,ii.
Do
not push the disc tray
in
by
hand when the power
is
turned off.
Doing
so
could damage the set.
• Only load one disc at a time. Loading
two
or more discs
can
damage
the unit or scratch the discs.
•
Do
not use cracked or warped discs or discs that
have
been repaired
with adhesive, etc.
• Do not use discs
on
which the sticky part of cellophane tape or labels
is
exposed or
on
which there are traces of where labels
have
been
removed.
Such
discs
can
get caught inside the player
and
damage
it.
•
"OOTr
00:
00"
is
displayed if a disc that cannot
be
played
is
loaded.
•
"OOTr
00:
00"
is
displayed if the disc
is
loaded upside-down or if
no
disc
is
loaded.
• Do not get fingerprints, oil or dirt
on
discs.
•
Take
special care not to scratch discs when removing them from
their cases.
•
Do
not bend or heat discs.
•
Do
not enlarge the hole at the center.
•
Do
not write
on
the labeled (printed) surface with ball-point pens,
pencils, etc., or stick
new
labels on discs.
• Water droplets may form on discs if they
are
moved suddenly from a
cold place (outdoors for example) to a warm place, but do not
try
to
dry them off using a hairdryer, etc.
•
Be
sure to remove discs after using them.
•
Be
sure to store discs
in
their cases to protect them from dust,
scratches, warping, etc.
•
Do
not store discs
in
the following places:
1.
Places exposed to direct sunlight for long periods
of
time
2.
Dusty or humid places
3.
Places exposed to heat from heating appliances, etc.
l-
Cautions
on
Handling-
•
Do
not touch the signal surface.
• Discs with special shapes (heart-shaped discs, octagonal discs, etc.)
cannot
be
played.
Do
not attempt to play them,
as
doing
so
can
damage the product.
• Some discs and some recording
formats may not
be
playable.
~
•
~I~~:~nalized
discs cannot
be
~
__
:::_
*What
is
finalization?
~
---
Finalization
is
the process that
makes recorded CD-R/CD-RW discs playable
on
compatible
players.
• Set the disc with the labeled side facing
up.
• Make sure the disc tray
is
fully open when inserting the disc.
•
Place
the discs flatly,
12
cm discs
in
the outer tray guide (Figure
1).
8
cm discs
in
the inner tray guide (Figure
2).
Figure 1 Figure 2
• Place 8 cm discs
in
the inner tray guide without using
an
adapter.
I
HolCliDi]lIiW~.·
3
To Next Page
Loading...
Need help?
General
