Denon TU-460 - Operation Instructions; Preparation and Connection Checks; Antenna Checks and Mode Notes

‘BE
FOLLOW THE PROCEDURES IN THE INDICATED ORDER.
FM OUTDOOR ANTENNA
AM LOOP ANTENNA =
ATTACH TO THE HOLDER
~ DENON AUDIO COMPONENTIAM-FM STEREO TUNER Tu-4e0
(AM-FM RANDOM 30CH Pigott
Wwawt
Da
aakke
CHIN
MULTI
FUNCTION
DISPLAY
SYSTEM
~10 0.0 OMMz C tIMEMO
OPERATION INSTRUCTIONS
PREPARATION
CHECKING CONNECTIONS
@ Check all the connections by referring to connection diagram (Fig. 1).
@ Check that the right (R) and left (L) channels of the speakers are connected to the corresponding right (R) and left (L) plugs, and
check that polarities (positive and negative) are correctly matched.
@ Check that the right (R) and left (L) pins are correctly inserted to the corresponding jacks.
@ Check that all the cords are firmly connected.
* Turn on the power with the POWER switch after checking all the connections.
CHECKING ANTENNA
1. Do not incorrectly connect the loop antenna. If you are not sure how to connect the loop antenna, refer to Fig. 1
2. Use of loop antenna: Keep the loop antenna away from the main body.; If the antenna contacts a metal body, reception sensitivity
is degraded, thus resulting in unclear reproduction.
Muiti-voltage model only
Setting the frequency step
Set the FREQUENCY STEP switch as described below.
@ Inthe U.S.A. and Canada — set the switch to 100 kHz/10 kHz side.
With this setting, the frequency varies in 100 kHz steps in the range of 87.5 to 108.0 MHz (FM) and in 10 kHz steps in 520 to
1710 kHz (AM).
Elsewhere — set the switch to 50 kHz/9 kHz side.
With this setting, the frequency varies in 50 kHz steps in the range of 87.50 to 108.00 MHz (FM) and in 9 kHz steps (AM) in
522 to 1611 kHz (AM).
CAUTION
1. Noise may be generated if a near-by television set is on during AM broadcasting reception. The tuner should be used as far
away from a television as possible.
2. Effective period of memory back-up is about a month under normal temperature. If the memorized stations cannot be called
back, preset the stations again.
NOTE ON ANTENNA MODE
This tuner is equipped with antenna mode “NORMAL” and “CABLE”.
In normal mode, antenna input signal is directly fed into front end, in cable mode, antenna input signal is attenuated. So it is
effective to use “NORMAL” to receive weak signals and “CABLE” to receive stronger signals, for instance, cable systems or local
stations.
Antenna mode is valid only for FM reception.