CHECKLIST for nalizing the installation:
1. Check all signals from the Intruder Alarm system, according to the selected diagram.
2. Has the NOZZLE been adjusted to the best position?
3. Make a full TEST SHOOTING at the installation site, to ensure that the dimensioning is OK.
4. Remember that the machine has to be HOT and READY before SHOOTING.
5. After TEST SHOOTING, insert a new and FULL fog rell. Remember to RESET the uid counter.
6. Have you and the customer considered a connection for this machine to the FREE CLOUD system ?
7. Make sure to give a full INSTRUCTION to the end-user of this installation.
8. Have you made a SERVICE and MAINTENANCE agreement with the end-user ?
13. Final test – Delivering the product
to the owner
14. Product information
page 18/20
www.densityglobal.com | help@densityglobal.com
Version 1.1.4
To Next Page
Loading...
