dentronix DDS 7000 - Maintenance and Cleaning; Fuse Replacement; HEPA Filter Replacement

To Next Page

To Previous Page

MAINTENANCE AND CLEANING

MAINTENANCE: Only the following three components are serviceable by the end user:

1) FUSE (located next to the power cord). In the event of no power to unit, (UNPLUG) disconnect from

electric supply and replace with correct amp fuse. (See General and Technical Specications, Page 5)

2) HEPA Filter located below unit. Remove magnetic strip and replace lter when dirty or if

an error code is indicated during cool-down cycle. An increased “Cool Down Cycle” time is a good

indication that the HEPA lter needs replacing. Replacement lter is available from Dentronix Inc. (Cat.

No. D7000F).

Fuse

Figure 14

HEPA Filter

Magnetic

cover

HEPA Filter

Figure 15