Why won't the boost power mode activate on my Dentsply Sirona Cavitron 300?
If the Dentsply Sirona Dental equipment Boost Power mode does not activate and the Diagnostic Display does not indicate “Boost” mode, it could be due to: * The Foot Control not being fully depressed. Make sure to depress the Foot Control fully. * A defective Foot Control. Replace the Foot Control.
Why do inserts slide out of my Dentsply Sirona Cavitron 300 Steri-Mate™ (360) during scaling?
If the Dentsply Sirona Dental equipment insert slides out of the Steri-Mate™ (360) during scaling, check these potential causes: * The Water Regulator / Solenoid might be set too high. Adjust it to the specified settings. * The handpiece water flow could be too high. Set the handpiece water flow control to approximately 35 cc/min. * The insert O-rings may be worn. Replace them.
Why is the Dentsply Sirona Cavitron 300 activating intermittently when using the foot control?
If the Dentsply Sirona Dental equipment experiences intermittent activation or no activation when stepping on the Foot Control, consider the following: * Check the Foot Control battery condition as indicated by the battery display, as weak batteries can cause this issue. * Ensure the distance between the Foot Control and Scaler is within 10 feet. * Follow the Cavitron® 300 Series scaler Directions for Use and Service Manual instructions for Foot Control synchronization.
How to fix Dentsply Sirona Cavitron 300 Dental equipment when Cavitron® 300 Series scaler does not power up?
If the Dentsply Sirona Dental equipment scaler does not power up and the touch screen doesn't illuminate, it could be due to: * A faulty wall outlet. Check the outlet and take corrective measures if needed. * The power cord not being fully inserted into the unit or wall outlet. Ensure the power cord is fully engaged. * A damaged power cord. Replace the power cord. * Blown fuse F3 and/or F4. Replace the internal fuses F3 and F4 with the specified fuses. * A damaged On/Off switch. Replace the On/Off switch.
What does service indicator 2 mean on my Dentsply Sirona Cavitron 300 Dental equipment?
If the Dentsply Sirona Dental equipment shows Service Indicator 2 in the upper left corner of the main screen, it could be due to: * The unit being installed in a confined area (such as a cabinet), or being too close to a heat source to ensure proper air circulation around the unit. Provide adequate air circulation around the unit. * A problem on the PC board(s). Return the Cavitron® 300 Series scaler to Dentsply Sirona Preventive Product Service for factory certified service.
General| Type | Ultrasonic Scaler |
|---|---|
| Frequency | 30 kHz |
| Water Flow Adjustment | Yes |
| Power Adjustment | Yes |
| Voltage | 100-240V |
| Frequency (Electrical) | 50/60 Hz |
| Tip Compatibility | Cavitron Inserts |
| Foot Control | Yes |
To Next Page
