Dentsply Sirona Gutta-Smart User Manual (English)

Other manuals for Dentsply Sirona Gutta-Smart

Questions and Answers:

S
Shannon DodsonAug 2, 2025
What to do if gutta-percha (GP) deposits on flow heater (HTR) of Dentsply Sirona Gutta-Smart?
- A
  Amber PruittAug 2, 2025
  If you notice gutta-percha deposits on the flow heater (HTR) or the GP push-rod, it may be because the HTR was removed before it had cooled. Always wait for the HTR to cool before removing it. Detach the HTR from the handpiece, which will automatically start retracting the GP push-rod. Press the cuff switch once to stop the push-rod. Gently remove the GP deposits using a soft brush, or a wooden or plastic probe. Avoid using a metal probe or forcefully scraping the HTR, as this will cause damage and void the warranty. Press the cuff switch again to alternate GP push-rod direction to facilitate GP removal.
J
John WrightAug 7, 2025
What to do if gutta-percha (GP) cartridge is stuck inside flow heater (HTR) of Dentsply Sirona Dental equipment?
- C
  carteralexaAug 7, 2025
  If a gutta-percha (GP) cartridge is stuck inside the flow heater (HTR) due to GP deposits, break off the cannula at the cartridge by bending it back and forth with your fingers. Then, use the handle of a wooden cotton swab to push the cartridge out of the HTR. Follow the instructions for removing GP deposits.
G
Gabrielle LangAug 13, 2025
Why gutta-percha (GP) doesn’t flow in Dentsply Sirona Gutta-Smart Dental equipment?
- R
  ricerobertAug 13, 2025
  If the gutta-percha (GP) isn't flowing, try increasing the flow temperature and flow rate. Also, GP may have accumulated around the GP push-rod. Follow the instructions for removing GP deposits.
M
Melissa TurnerAug 17, 2025
What to do if pack or flow handpiece is malfunctioning in Dentsply Sirona Gutta-Smart?
- W
  Willie LucasAug 17, 2025
  If the pack or flow handpiece is malfunctioning, turn the handpiece off and then back on again. If the handpiece still appears to be malfunctioning, contact Dentsply Sirona by phone or online at the contact information shown on the back cover page of this manual, or contact your Dentsply Sirona authorized service partner.
W
William RamirezAug 22, 2025
What to do if flow heater (HTR) doesn’t heat up in Dentsply Sirona Dental equipment?
- S
  shuffAug 22, 2025
  If the flow heater (HTR) doesn’t heat up, place the flow handpiece (with HTR installed) into the base station and activate the programming screen by pressing the side of the touch-screen below the flow handpiece. If the heater icon appears with an “X” the HTR may be defective. Try reseating the tip or replacing it with a different one.
E
Eric CrawfordAug 27, 2025
How to fix electric heat plugger (EHP) that doesn’t heat up in Dentsply Sirona Gutta-Smart Dental equipment?
- C
  cynthiapalmerAug 27, 2025
  If the electric heat plugger (EHP) or thermal response tip (TRT) doesn’t heat up, place the pack handpiece (with EHP or TRT installed) into the base station and activate the programming screen by pressing the side of the touch-screen below the pack handpiece. If the heater icon appears with an “X” the EHP or TRT may be defective. Try reseating the tip or replacing with a different one.