EasyManua.ls Logo

Denver ACK-8060W User Manual

Denver ACK-8060W
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ACK-8060W Quick Start Guide
ENG 1
I
I
n
n
t
t
r
r
o
o
d
d
u
u
c
c
t
t
i
i
o
o
n
n
t
t
o
o
a
a
p
p
p
p
e
e
a
a
r
r
a
a
n
n
c
c
e
e
a
a
n
n
d
d
k
k
e
e
y
y
s
s
S
S
t
t
a
a
r
r
t
t
u
u
s
s
i
i
n
n
g
g
_
_
_
_
_
_
_
_
_
_
_
_
_
_
1. Charge the built-in lithium battery
Connect the camera to the computer for charging, at this time, the
charging indicator will be in blue, and it will be off after charging.
Generally, it takes 2-4 hours to charge the battery.
2. Use the storage card
2.1. Push the Micro SD card into the slot till it is in place as per the
instruction in concavely engraved words by the storage card slot.
2.2. To take out the Micro SD card, press the tail of the storage card
inwardly softly and it will be popped out.
Please notice: UHS (ultra high-speed) cards doesn’t work, as they are
not 100% backward compatible
Note: There’s no built-in memory unit in the camera, so make sure to
insert a storage card into it prior to use (it is recommended that a Micro
SD card of better quality be used).
3. Power on/off
3.1 Power on: Press Power key for 3 seconds, the screen will be on and
the camera will be started.
3.2. Power off: Press Power key for 3 seconds when the camera is in
the idle state to turn it off.
3.3. Power off when the camera is lack of electricity. When electrical
quantity of the battery is very low, an icon of will be displayed
on the LCD screen, prompting you to charge it in time. When the icon
turns red and flickers, the camera will be turned off automatically.
4. Shift among functional modes
The camera has 3 modes, namely video recording mode, shooting
mode and replay mode. After power is on, press Power key to shift
among them.
Video recording mode shooting mode
Replay mode
5. Indicator
Busy indicator (red): When the camera is busy such as recording videos,
shooting photos and turning off screen automatically, the work
indicator will light.
Charging indicator (blue): When it is on, the user is prompted that the
camera is being charged and it will be off after charging is completed.
6. Video recording mode
After power is on, the camera will enter video recording mode directly
and in preview mode, press Shutter key to start video recording; Press
it again to stop shooting. If the memory card is full or electrical
quantity is low, it will also stop shooting:
1. Icon of mode, indicating video recording mode;
2. Indicate size of video, and 4K (30FPS)/2.7K (30FPS)/ 1080P (60FPS)
/ 1080P (30FPS) / 720P (90FPS) / 720P (60FPS) /
720P (30FPS) is optional;
3. Recording time, indicating recordable length of time;
4. Icon of battery, indicating current electrical quantity;
(With maximum 29 minutes video recording and then stop. Must be
Started manually on the camera again.)
7. Shooting mode
After power is on, press Power key twice to enter shooting mode, and
in preview state, press Shutter key to take a photo:
1. Icon of mode, indicating the current is shooting mode;
2. Size of video, and 2M/5M/8M//12M/16MP is optional;
3. Icon of electrical quantity of battery.
4. Recording time.
USB cable
Question and Answer IconNeed help?

Do you have a question about the Denver ACK-8060W and is the answer not in the manual?

Denver ACK-8060W Specifications

General IconGeneral
Frame rate at maximum resolution30 fps
Wi-FiYes
Storage mediaMicroSD card
Maximum storage capacityUp to 64 GB
Frame Rate30 fps
Lens Angle170 degrees
ScreenLCD
Battery900 mAh
Maximum video resolution3840 x 2160 pixels
WaterproofUp to 30 meters with case
Screen size2.0 inches
MemorySupports Micro SD card (not included) up to 64GB
ConnectivityMicroUSB

Summary

Introduction to Camera Appearance and Keys

Video Recording Mode Operations

Guides on starting/stopping video recording, available resolutions, recording time, and battery icon.

Still Photo Shooting Mode

Instructions for entering shooting mode and taking photos, including resolution and recording time.

Start Using the Camera

Charging the Battery

Explains how to charge the built-in battery using a USB cable and computer.

Using the Storage Card

Details on inserting and removing the Micro SD card, and compatibility notes.

Mobile App Integration

Obtaining the Mobile App

Guides on how to find and install the DENVER ACTION CAM 3 app for Android and iOS devices.

Camera Wi-Fi and App Integration

Details on connecting the camera to a mobile device via Wi-Fi to use the app functions.

Related product manuals