Denver AC-5000W MK2 User Manual (English)

To Next Page

AC-5000W MK2 Quick Start Guide

ENG 1

Camera Diagram:

LCD Display Diagram:

Turn on the Wi-Fi camera, the LCD will display the following status and settings:

1. Camera mode

2. Video recording mode (default)

3. Wi-Fi icon (display when enabled)

4. Micro SD card icon (display when loaded)

5. Resolution icon:

In camera mode, HI stands for 8 Mega Pixels (interpolated) (3264x2448), and in video

recording mode, it stands for FHD (1920x1080, 30fps);

In camera mode, LO stands for 5 Mega Pixels (2592x1920), and in video recording mode,

it stands for 720P (1280x720, 30fps);

HILO only displays in video recording mode, standing for 720P (1280x720,60fps).

6. Mute mode, displays when enabled, and disabled by default.

7. Counter, displays up to 999.

8. Timer, displays hours and minutes.

9. Battery icon: current battery level of the camera.

Note: The above icons may vary according to the status of the camera.

Using your camera:

1)When you use the camera for the first time, please:

Insert a micro SD or micro SDHC card (not included), as shown in the following picture.

A Class 10 Micro SD Card is required for this camera.

Turn off the camera before inserting or removing the card.

2)Turn on/off

1, Turn on: press and hold the button for about 3 seconds, LCD displays “ON” and a

beep can be heard from buzzer.

2,Turn off: press and hold the button for about 3 seconds, LCD displays “OFF” and a

beep can be heard from buzzer.

3)Start to Use

1. Default setting: After turn on the DV, the default setting is as below:

Video recording

mode icon

The DV is in video recording mode.

Video resolution FHD: 1080p@30fps

Recording time Stands for 0 hour and 00 minute.

Micro SD card

icon

Display when a Micro SD card is inserted,

otherwise no display.

Battery level Battery is full

Mute icon

The DV is in Mute mode, no Beep will be heard

when pressing the buttons. It displays only

when Mute mode is activated.

Wi-Fi icon Display when activated.

2.Shooting modes. The DV provides different shooting modes. Press the button

repeatedly, the following first two modes will show on the DV screen , and other models

display on the APP operation.

Video

HI stands for FHD (1920x1080,30 fps) video

Lo stands for 720P (1280x720,30 fps) video

HILO stands for 720P (1280x720,60 fps) video

Photo

HI stands for 8M (3264 x 2448) resolution

Lo stands for 5M (2592 x 1920) resolution

Continuou

s shot

The DV supports taking 3 photos continuously

(only via App)

Self-timer

In self-timer mode , you can set 0s, 2s or 10s (only

via App)

3, Video

( With maximum 29 minutes video recording and then stop.Must be started manually on

the camera again.)

To record a video, please check whether the DV is under Video mode. If the icon is

not displayed on the screen, press the button repeatedly until it appears.

Start recording: Press and release the button, the icon and [:] displayed in

LCD will flash. At the same time the red indicator will flash too, meaning the recording is

in process.

Stop recording: Press and release the button, the icon and [:] displayed in

LCD will stop flashing. At the same time the red indicator will stop flashing either, meaning

the recording is stopped.

When the Micro SD card is full, or the battery runs out, the recording will stop

automatically, and the recorded video will be saved before the DV turns off. Stops

automatically when 29 minutes of video recording is reached.

4. Photo

To take a photo, please check whether the DV is under Camera mode. If the icon is

not displayed on the screen, press the button repeatedly until it appears.

Press and release the button, a beep will be heard and the red indicator will flash,

meaning a photo is taken.(If you take photos more than 999 copies, the LCD screen

display only 999)

5. Enable/disable Wi-Fi

The Wi-Fi is disabled by default. Press the Wi-Fi button on the side of the DV to enable it.

When starting connecting to Wi-Fi network, the indicator will flash, and when a Wi-Fi

network is connected, the indicator will remain on, and the Wi-Fi icon will display on LCD

screen.( In order to save power, Wi-Fi will be automatically disabled if no terminal is

connected after 30 seconds)

1. Shutter button 8. Micro SD card slot

2. Microphone 9. Micro USB port

3. LCD display 10. Battery cover push switch

4. Lens 11. Charge/Busy light

5. Wi-Fi switch and status indicator (red) 12. HDMI Port

6. Power /Mode button

7. Infrared signal reception light

Wi-Fi er disabled by

default

When Wi-Fi is enabled, the

Wi-

Fi icon will display on LCD

Need help?

Do you have a question about the Denver AC-5000W MK2 and is the answer not in the manual?

Denver AC-5000W MK2 Specifications

General

Aspect ratio	16:9
Video resolutions	1280 x 720, 1920 x 1080 pixels
Maximum frame rate	60 fps
Supported video modes	720p, 1080p
Video formats supported	H.264, MOV
Maximum video resolution	1920 x 1080 pixels
Photo mode	Yes
Sensor type	CMOS
Total megapixels	5 MP
Image formats supported	JPG
Maximum image resolution	3264 x 2448 pixels
Still image resolution(s)	3264 x 2448, 2582 x 1344
Flip-out screen	-
Field of view (FOV) angle	120 °
RAM type	DDR3
RAM capacity	1 GB
Storage media	Memory card
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	32 GB
GPS (satellite)	No
USB connector type	Micro-USB
USB 2.0 ports quantity	1
Product color	Black, Silver
Battery capacity	1000 mAh
Battery life (max)	2.2 h
Battery technology	Lithium
Mobile operating systems supported	Android, iOS
Quantity per intermodal container (20ft)	6560 pc(s)
Quantity per intermodal container (40ft, HC)	15560 pc(s)
Cables included	USB
Underwater case waterproof up to	55 m
Operating temperature (T-T)	-30 - 70 °C