1.Insert big USB end of the 2 in 1 USB to unit,
insert another 3.5mm charging end of the
2 in 1 USB to 3.5mm working jacket
2. After 3-5 seconds, pull out USB, then
connected to charger then unit LED red,then
Bluetooth can work
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S
Electric and electronic equipment and included batteries contains materials, components and substances
that can be hazardous to your health and the environment, if the waste material (discarded electric and
electronic equipment and batteries) is not handled correctly.
Electric and electronic equipment and batteries is marked with the crossed out trash can symbol, seen
below. This symbol signifies that electric and electronic equipment and batteries should not be disposed of
with other household waste, but should be disposed of separately.
As the end user it is important that you submit your used batteries to the approriate and designated facility.
In this manner you make sure that the batteries are recycled in accordance with legislature and will not
harm the environment.
All cities have established collection points, where electric and electronic equipment and batteries can
either be submitted free of charge at recycling stations and other collection sites, or be collected from the
households. Additional information is available at the technical department of your city.
Hereby, Inter Sales A/S, declares that this product BPB-100C is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of
conformity may be obtained at: Stavneagervej 22, DK-8250 Egaa, Denmark
Imported by: DENVER ELECTRONICS A/S, Stavneagervej 22, DK-8250 Egaa, Denmark
To Next Page
Loading...
