2. MODE: to switch between the modes;
3. MUTE: to mute;
4. : Press to play/pause music.
5. EQ: to set equalizer variants;
6. 0-9: to select a song directly;
7. RPT: to repeat the song;
8. to select the previous song from USB / TF/ BT;
9. to select the next song from USB/TF / BT;
10. VOL+: to increase volume;
11. VOL-: to reduce volume;
12. Switch between USB and SD card. ;
Please notice: When using the remote control to control the speaker, please point vertically from
the top. The remote sensor is located there. It cannot be accessed directly from the front of the
speaker.
FUNCTION DESCRIPTION
1. Charge the speaker
To charge the speaker’s built-in battery, connect power adaptor (not supplied) to the charging port.
The battery icon on LED will flash when charging, and will stop flashing when fully charged.
2. Bluetooth function
Power on the product then long press MODE button to enter BT mode.
Put your mobile device (cell phones, computers, etc.) into BT pairing mode, search for BT
devices, and select the item name (Denver BPS-250) when it appears.
After the device has been paired successfully for the first time, it will connect automatically in
around 10 seconds to the device last connected when next time use. (Note: The product can
connect to only one Bluetooth device at a time.).
3. TWS Function
Power on two speakers and enter Bluetooth mode.
To Next Page
Loading...
