5. To tune to a preset station, press the PRESET button once, then press the
BACKWARD or FORWARD button to cycle through the list of preset stations and then
press the SELECT button to confirm the selection.
To change the DAB station assigned to a preset number, repeat steps 1 to 4 above to
overwrite the existing DAB station.
Displaying DAB information
Press the INFO button repeatedly to cycle through the following information (if available).
• Dynamic label segment (DLS)
• Signal strength
• Program type (PTY)
• Ensemble name
• Frequency
• Signal error rate
• Bitrate codec
• Time
• Date
Using the DAB menus
1. In DAB mode, press and hold the MENU button to access the DAB menus.
2. Press the BACKWARD or FORWARD button to cycle through the below options.
• Full scan
• Manual tune
• DRC
• Prune
• System
See below for details of each option.
Full scan
Full scan is used to perform a wide range search for DAB stations.
• Press the SELECT button to start scanning for available DAB stations. After the
scanning is complete, the first detected station is broadcast automatically.
Manual tune
1. Press the SELECT button to confirm the selection “Manual tune”.
2. Press the BACKWARD or FORWARD button to tune the frequency manually.
DRC (Dynamic Range Control)
DRC adds or removes a degree of compensation for the differences in the dynamic
range between radio stations.
To Next Page
Loading...
