ALARM 1 SETTINGS
Alarms will only function when the unit is On (mains or battery power) or in Standby mode (Mains
power only).
Alarms can be switched on or off in standby mode (see below), however, the alarm parameters can
only be set when the unit is on.
To setalarms
Turn the uniton.
To set or change alarm 1, press “ALARM” once, then press “TUNE/SELECT”. To set or change alarm
2, press “ALARM” twice, then press ”TUNE/SELECT”. To exit alarm setting mode, press “ALARM”
again.
The alarm setup prompts you for the following parameters. Select a value for each parameter in turn
turning the “TUNE/SELECT” knob and press “TUNE/SELECT” to confirm and move on to the next
parameter.
Parameters
• On time – hours and minutes
• Duration–15 | 30 | 45 | 60 | 90minutes
If the alarm is not cancelled the unit returns to standby after this time period.
• Source– Buzzer/ DAB/ FM
If DAB or FM is chosen as the audio source you will also be prompted to select the Last played station
or one of the preset stations (if set).
• Daily | Once | Weekends | Weekdays
Choose the days on which the alarm isactive.
Note: if you choose ‘Once’, you are prompted to enter the required date.
• Alarm–Off | On
USING THE AUX INPUT
Connect the AUX connect wire from the out jack of your Personal Player such as portable MP3 player
to the AUX input jack.
Press the DAB/FM/AUX/BT button to select AUX mode, “Auxiliary Input” will show on the LCD.
Turn on your Personal Player to begin playing, adjust the volume to desire listening level.
IN Bluetooth MODE
Press the DAB/FM/AUX/BT button to select BLUETOOTH mode
To pair the radio with your phone:
Turn on the Bluetooth function in the phone or tablet. For instructions, see your mobile phone user
guide.
a. Place the phone within 20 cm (8 inches) of theradio.
b. Please make sure the radio is in BT mode. Choose “DAB-18” on your phone to connect the
radio Bluetooth. After connected, your phone will show “BTConnected”.
c. Enjoy your music with the radio now!
To Next Page
Loading...
