Denver DMP-389 - Page 6

NOTE: The unit will turn off at the end of the CD or after 30 seconds of
inactivity.
9. To remove the CD Disc/MP3 Disc, open the Unit Door, ensure the CD/MP3
Disc has stopped spinning, and then carefully remove it from the spindle.
10. Close the Unit Door.
CAUTION: If using the product with an adapter, disconnect it from the
outlet.
NOTE: When the Battery Replacement Indicator, tam flashes in the Display,
replace the batteries.
Playback Modes:
Repeat
* To play a single track repeatedly, press the Mode Button repeatedly until
“REP 1” appears. Press the Play Button if playback is stopped.
* To play the entire CD repeatedly, press the Mode Button repeatedly until
“REP ALL” appears. Press the Play Button if playback is stopped.
* To cancel the Repeat Function, press the Mode Button repeatedly until
“REP 1” or “REP ALL” disappears.
Random Play
* Press the Mode Button repeatedly until the “RND” Indicator appears.
Press the Play Button to begin playback of tracks in a random sequence.
* To cancel this function, press the Mode Button repeatedly until “RND”
disappears.
Programmed Play:
1. Press the Stop Button during playback.
2. Press the Program Button and select the desired track by pressing the
Previous l¢4 or Next >>! Button, and then press the Program Button again
to program the track.
3. Repeat Step 2 for all tracks to be programmed.
4. Press the Play Button to begin the programmed playback.
NOTE: When playback stops, the programming will be erased.
5. To cancel programmed playback, press the Stop Button.
Resume Playback
1.Press pil once to pause the current track,press pil once more to resume
playback.
2.Press bil to resume playback.