2.3 Operation Instructions
1) Long press instrument key, instrument panel display blue light, the scooter is on.
2)
Press the throttle near your right thumb, the scooter starts; continue to press the throttle, the
speed increases, loosening the throttle, the speed decreases.
3)
The left hand side is the electronic brake, press the electronic brake to execute the brake
functions, release the electronic brake to cancel the brake function.
4)
Heel touch on the mechanical brake, can impliment the mechanical brake, as shown in figure.
5)
Long press the instrument key, instrument blue light disappears, the scooter power off.
2.4 Parameter Settings
L
ong press key + at the same time enter to the SET (parameter setting), followed by zero or
non-zero start, the motor pole log ratio, wheel diameter settings.
1). Short press key, when display 1, enter zero start and non-zero start horizontal setting. When
parameter value is 0, it will start with zero. When parameter value is 1, it will start non-zero.
(Zero start: When starting, the scooter in the stationary case, press the switch to start walking,
factory default is zero start.)
(Non-zero start: When starting, the scooter is static, press the switch and the scooter does not work,
manually start riding , the scooter works. )
2). Long press again to exit the setting state, and save the set parameters.
3). Failure model indicator
When the electric scooter breaks down, the failure meter will display what section breaks
down, such as: brake failure , motor failure , handlebar failure , controller
failure etc.
Light on the mechanical brake pads
Figure (1)
To Next Page
Loading...
Need help?
General
