Denver E-1000 - User Manual

Questions and Answers

W
William FryAug 29, 2025
How to fix Denver Bicycle when charger indicator LED is not lit?
- W
  williamsmaryAug 29, 2025
  If no charger indicator LED lights up after plugging in your Denver Bicycle, there might be a problem with the power outlet itself. Check the outlet and repair if necessary. Ensure the charger input plug is making good contact with the power outlet by inserting it firmly. Very low temperatures can also affect charging. The suggested solution is: 1) check and repair the power outlet. 2) check and insert the power outlet tightly. 3) charge it in house. If the above has no effect, please contact your vendor or authorized service.
C
catherine28Nov 5, 2025
Why Denver E-1000 Bicycle motor does not generate assistance when pedaling?
- G
  georgekimberlyNov 5, 2025
  If the Denver Bicycle motor isn't providing assistance when pedaling after switching on the main battery, several factors could be at play. First, ensure the battery isn't empty and charge it if needed. Check that the motor cable connection is secure; if it's loose, tighten it. Make sure the brake lever returns fully to its normal, non-braking position. Inspect the battery fuse for breakage, and if broken, have it replaced by a qualified technician. Verify the speed sensor is within 3mm of the magnetic ring on the B.B. axle, adjusting if necessary. Finally, confirm the connection between the sensor and the controller is firmly in place. The suggested solution is: First of all, please check the battery if it is empty. If yes, charge the battery immediately. 1) check if the connection is sec...
S
Shari LangNov 13, 2025
Why Denver E-1000 Bicycle distance per charge becomes short?
- J
  Jeremy MeyersNov 13, 2025
  If your Denver Bicycle isn't traveling as far per charge as it used to, several factors could be responsible. Ensure the battery is charged fully, following the instructions. Remember that cold temperatures can reduce battery performance, so storing the battery indoors in winter is advisable. Frequent uphill riding, strong winds, or poor road conditions can also shorten the distance per charge. Check that your tires are inflated to 45psi. Frequent braking and starting can also reduce the range. Also, if the battery has been stored unused for a long period of time, it may affect the distance per charge. The suggested solution is: 1) please charge the battery according to the instruction (chapter 7.3); 2) in winter or under 0°C, you’d better store the battery inside the house; 3) it will be ...
T
trevinomichaelNov 20, 2025
What to do if Denver E-1000 Bicycle charger LED is still red after charging?
- S
  Shannon GallagherNov 20, 2025
  If the charger indicator LED on your Denver Bicycle remains red after 4-5 hours of charging, and the battery isn't full, several issues could be the cause. Charging in temperatures at or above 40°C or below 0°C can prevent the battery from fully charging. Also, letting the bike battery over-discharge by not charging it after riding can cause problems. Low output voltage can also be a factor. The suggested solution is: 1) charge the battery in an area under 40°C, or according to this instruction chapter 7; 2). charge the battery inside the house, or according to this instruction chapter 7; 3) please well maintain the battery according to the Chapter 6.3 to avoid natural over-discharge; 4) no charging when the power supply is lower than 100V. If the above has no effect, please contact your v...