Denver Orus E-3600 - User Manual

Questions and Answers

J
Joshua WallaceAug 4, 2025
What to do if the Denver Orus E-3600 Bicycle motor doesn't assist when pedaling?
- E
  Elizabeth RussellAug 4, 2025
  If the Denver Bicycle motor isn't assisting, check these potential causes: 1. Ensure the motor cable connection is secure. If it's loose, tighten it. 2. Make sure the brake lever returns to its normal position without braking. 3. Inspect the battery fuse for breaks and replace it if necessary. 4. Adjust the distance between the magnetic ring and the speed sensor to be within 3mm. 5. Confirm the connection between the sensor and the controller is tight.
S
saracummingsAug 9, 2025
Why does my Denver Orus E-3600 Bicycle distance per charge become short?
- T
  toddhendersonAug 10, 2025
  If your Denver Bicycle's distance per charge is shorter than expected, consider these factors: * Ensure the battery is charged according to the instructions. * If it's cold (below 0°C), store the battery indoors. * Riding uphill, against the wind, or on poor roads can reduce distance. * Check and inflate your tires to 45psi. * Frequent braking and starting affect the distance. * Regularly charge the battery, especially after long storage.
W
walshsusanAug 15, 2025
What to do if Denver Orus E-3600 Bicycle charger indicator LED is not lit?
- V
  vhartAug 15, 2025
  If the Denver Bicycle charger indicator LED doesn't light up after plugging in, try these steps: * Check the power outlet and repair it if necessary. * Ensure the charger input plug is securely inserted into the power outlet. * If the temperature is too low, charge it indoors.
M
Michael RichardAug 22, 2025
Why is my Denver Orus E-3600 Bicycle charger LED still red after charging for hours?
- D
  David ChenAug 22, 2025
  If the Denver Bicycle charger LED remains red after 4-5 hours, consider these reasons: * The environment temperature may be too high (40°C and above). Charge in a cooler area. * The environment temperature may be too low (under 0°C). Charge the battery inside. * The bike may have failed to charge after riding, resulting in over discharge. Maintain the battery well to avoid natural over-discharge. * The output voltage may be too low to charge the battery. Avoid charging when the power supply is lower than 100V.
A
Amber KennedyAug 28, 2025
How to fix no speed/KM show on the LCD of Denver Orus E-3600 Bicycle?
- M
  Mike BradyAug 28, 2025
  If there's no speed/KM display on your Denver Bicycle's LCD, check the distance between the magnetic ball point on the wheel spoke and the wheel speed sensor. Ensure the distance is within 5mm.