2. You can use the controls on your paired BT device as well as those on the Retro
Turntable when listening to music via BT.
Controls available on your product are:
Play/Pause
Short press to play/pause .
Note: If you long press the button for 3 seconds, you can disconnect the current
BT device and search for new devices.
Skip back
Short press the Tune/Skip - button.
Skip forward
Short press the Tune/Skip + button.
Note: If you do not use or pause your Retro Turntable for approximately 15 minutes
and no audio signal is received, it will automatically go to Standby mode.
AUX IN MODE
Check that your Retro Turntable is in Aux in mode. If you are not in Aux in mode,
repeatedly short press the Source button to go to Aux in mode (check the display).
Using a 3.5mm audio input connection cable (not included), Aux in allows for a quick
and easy connection to an external sound source.
1. Connect one end of the 3.5mm audio connection cable to the headphone (or
auxiliary out) socket of your secondary device, connect the other end to the Aux in
socket on the front of your Retro Turntable.
2. Press the Play button on your external device to start playback through the Retro
turntable speakers. To gain optimal volume levels, adjust the output volume level
on both the secondary device and on the Retro turntable.
Note: It is recommended that you unplug the Audio cable from the Aux in socket after
you have finished listening to your external device.
To Next Page
Loading...
