5
CAUTION
Stacking
■ Improper stacking of machines may cause falling or
dropping accidents. When stacking other machines on this
machine, be sure to observe the following points.
* Check that the bonnet of the machine is free from damage and that
the fixing bolts are not loosened and missing.
* Put the machine horizontally on a solid foundation which
withstands the weight of stacked machines.
* Machines can be stacked up to 2 stages. The weight and size of
stacked machines should be less than those of this machine.
* Using square timbers as shown right, put each machine making
sure that the weight is even.
■ Do not operate the machines in the state of stacking to prevent
falling or dropping accidents.
CAUTION
HOT PARTS can burn skin.
■ High temperature units are located in the machine.
(Note that these units are very dangerous if they are used
incorrectly.)
* Be sure to close the door and lock it during operation.
* If the door needs to be opened during operation, do not get your
hands and head in the machine to prevent unexpected burns.
* When making check or maintenance of the machine, be sure to
stop the machine.
* The bonnet is still hot even after the machine is stopped. Be
careful until the engine is completely cooled.
To Next Page
Loading...
