(2) Replacement of engine oil filter element
Ф Remove the cartridge type element (cartridge)
using filter wrench.
ф Clean the filter base. Coat the packing of new
cartridge with engine oil thin. Then, mount the
cartridge.
■ When mounting, tighten the cartridge from
3/4 to 1 turn by using filter wrench after the
packing is fitted to the seal of the filter base.
® After the element is replaced, run the engine
for a while. Then, check to see that oil is
supplied to the level between H and L .
Г 5—1.(1) Checking on engine oil See p.35j
Parts number of oil filter cartridge :
KOMATSU 600- 211-1231 (Two elements are used.)
-65 -
To Next Page
Loading...
