(1) Preheat lamp
This machine has automatically preheating device.
If turn the starter switch to “RUN” position, it will according to
cooling water (coolant) temperature with the preheat lamp goes on.
When the preheat lamp goes off, it indicates that preheating is
completed.
(2) Warning Lamps
This monitor indicates the following failures, if any one of them occurs.
® High jacket water temperature (WATER TEMP)
This lamp goes on when the water temperature rises abnormally. If
the lamp goes on during operation, the emergency stop
device immediately operates to shut down the engine automatically.
Indication/alarm lamp
Ф Oil pressure failure (OIL PRESS)
If this lamp goes on during operation, the emergency stop device
immediately operates to shutdown the engine automatically.
(D Air filter blinding (AIR FILTER)
When the air element is blinded, this lamp goes on. Indicating that
the element should be immediately cleaned or replaced.
® Over speed of engine (OVER SPEED)
This lamp goes on when the engine speed rises abnormally. If the
lamp goes on during operation, the emergency stop device
immediately operates to shut down the engine automatically.
To Next Page
Loading...
