[Note] vibration:
The engine, running, generates vibration during operation of the machine.
When installing the machine, be sure to observe the following points.
* Install the machine horizontally on a solid foundation. Operation on an uneven place
will generate unusual vibration.
* The machine should be installed on a substantial base to prevent claims from nearby
living people. For details of the vibration level of the machine and foundation work,
contact distributor or our office.
[Note] noise:
The engine is running during operation of the machine.
If the door is open, much noise will be generated. But some noise will stay, when door
is closed.
When installing the machine, be sure to observe the following points.
* Close and lock the door after installation,
* We recommend to execute the measure for sound level to prevent claims from
nearby living people.
Installation procedure
* Install the machine horizontally on a solid foundation.
* Provide a space of more than about lm at the side of the control panel and fuel feed
port to ensure correct operation and supply.
* Provide a space of more than about 1.2m on the left and right sides for check of the
engine, oil supply and cable connection work.
* A sufficient space is required at the top of the machine to allow hot air (exhaust air)
from the radiator and exhaust gases to be discharged and to supply water to the
radiator.
* When the machine is operated in a place with much dust or salt, careful maintenance
is required to prevent clogging or damage to the radiator or poor insulation of
electric parts.
Indoor installation
* Exhaust gases should be discharged outdoors using an
exhaust pipe.
* Exhaust air should also be discharged outdoors using a
duct or the like.
* Insufficient indoor ventilation will raise the (indoor)
temperature and affects the performance of the machine.
* For details of required volume of ventilation, contact
distributor or our office,
17
To Next Page
Loading...
Need help?
General
