Desa GA3650TB - Installation Preparation & Safety

www.desatech.com
108321-01B2
Figure 1 - Removing Log Base from Fireplace
Screws
Log Base
Flexible Gas Line
INSTALLING BLOWER
ACCESSORY IN A 32"
FIREPLACE SYSTEM
IMPORTANT: Read all installa-
tion instructions before install-
ing blower.
NOTICE: Shut off gas supply and
disconnect heater from gas sup-
ply. Contact a qualied service
person to do this.
Note: Appearance of rebox may vary depending
on model.
1. Remove replace screen or front glass per the
instructions in operation manual supplied with
replace.
2. If logs are installed, carefully remove the logs
and set aside, noting the properly mounted
location of each.
3. Remove screws that attach log base assembly
to replace (do not discard). Carefully lift up
log base assembly and remove from replace,
taking care to pull exible gas line through the
access holes (see Figure 1).
CAUTION: Do not pick up log
base assembly by burners. This
could damage burners. Only
handle base by grates.
Screws