www.desatech.com
119303-01E
5
PRODUCT IDENTIFICATION
Figure 1 - Log Base Assembly
Log Set
Base
Assembly
Front
Burner
Rear
Burner
Top Louver
Assembly
Fireplace
Hood
Bottom Louver
Assembly
Screen
Assembly
Top Outer Casing
Figure 2 - Fireplace
UNPACKING
Blower Assembly
BLOWER ASSEMBLY
This replace has a blower assembly. The
blower operates thermostatically and has a
variable speed control. The blower circulates
heated air from the replace into the room.
Use of blower is optional.
THERMOSTAT CONTROL
This replace has a thermostat sensing bulb
and control valve. The thermostat controls the
heat output and ame height. This maintains
a consistent room temperature. Even the
lowest setting provides realistic ames and
glowing embers from two burners. Selecting
higher comfort settings allows replace to run
longer, producing greater heat output. At lower
comfort settings, the replace will run less.
This results in increased heating comfort. This
can also result in lower gas results.
CAUTION: Do not remove the
1. With utility knife, cut carton all the way
around above staples on bottom tray. Lift
carton off of heater. Remove packing.
Note: Hood is located in packing on right
hand side of heater front. Lift heater off
bottom tray.
2. Locate two screws above top corners of
the replace screen. Remove and discard
these screws. Lift replace screen up and
pull out to remove.
3. Remove protective packaging applied to
logs, log base assembly, and replace.
4. Remove replace hood from carton insert.
5. Check all items for any shipping damage.
If damaged, promptly inform dealer where
you bought replace.
PRODUCT FEATURES
This vent-free replace is clean burning. It
requires no outside venting. There is no heat
loss out a vent or up a chimney. Heat is gen-
erated by both realistic ames and glowing
embers. When used without the blower, the
replace requires no electricity making it ideal
for emergency backup heat.
SAFETY DEVICE
This replace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS/pilot is a required feature
for vent-free room heaters. The ODS/pilot
system shuts off the replace if there is not
enough fresh air.
This replace has a piezo ignitor. This sys-
tem requires no matches, batteries or other
sources to light replace.
To Next Page
Loading...
