Why is my DESKHAUS Indoor Furnishing desk not working?
If your DESKHAUS Indoor Furnishing desk isn't working, it might be due to the control box duty cycle. Allow the desk to rest for 16 minutes. Also, the environment temperature may be too high for operation.
What to do if I have a control box error with master/slave connection on my DESKHAUS APEX/2?
First, verify that all plugs are properly connected to the control box. Then, perform a base reset. Inspect the cord and plug for any damage, and replace them if necessary. If the issue persists, the control box may need replacement. Note that Master/Slave systems are custom installations, and customer service assistance may be needed.
Lists all components and their quantities for assembly.
Lists required tools for the assembly process.
Connects the desk columns to the collapsing channels using M6 10mm screws.
Secures the feet to the desk columns using M6 14mm screws.
Attaches the top supports to the desk columns with M6 14mm screws.
Attaches the assembled frame to the desk surface using 7/8" wood screws.
Secures the adjustable channels using M6 10mm screws for proper cable management.
Mounts the control box and hand switch using 16mm wood screws.
Connects the hand switch, column power cords, and main power cord to the control box.
Guides the user through calibrating the desk's height sensors for accurate operation.
Explains how to operate the desk's height adjustment using the paddle.
Details how to set and recall preferred seated and standing desk heights.
Describes how to quickly move between saved seated and standing positions.
Explains how to configure reminders for sitting or standing breaks.
Covers setting height limits, locking the handset, and vibration mode.
Provides solutions for common error codes related to desk operation.
General| Brand | DESKHAUS |
|---|---|
| Model | APEX/2 |
| Category | Indoor Furnishing |
| Language | English |
To Next Page
