To Next PageTo Next Page
Need help?Do you have a question about the Desoutter CONNECT-W and is the answer not in the manual?
Highlights critical safety instructions and warnings for product operation.
Configuration details for Ethernet and Wi-Fi network settings.
Instructions for powering the system on and off.
Configuring CONNECT-W with one wired network connection.
Configuring CONNECT-W with two wired network connections.
Setting up networks when the Wi-Fi access point is not enabled.
Linking CONNECT-W's embedded wireless network to Ethernet.
Steps to create a tightening unit and associate a tool.
How to run a Pset and view the tightening results.
Steps for creating a new assembly process.
Procedure for executing a configured assembly process.
How to view the results of an assembly process.
How to view and interpret tightening results.
Managing features: checking status and adding new ones.
Procedures for backing up data via USB and creating snapshots.
Detailed steps for the UV rebalancing process.
Verifying the successful transfer of UVs during rebalancing.
Instructions for managing UV counters within the system.
Details on UV assignment and requirements for features.
How to read UV graphs and check available UV amounts.
Procedure for rebalancing UVs (Unit Values) to the RIM.
Retrieving identification and characteristics of connected tools.
Accessing configuration details for a connected tool.
Monitoring tool counters and operating temperature.
Checking the calibration status of the tool.
Troubleshooting steps when a tightening unit is inactive.
Steps to take when the connection with the tool is lost.
Highlights critical safety instructions and warnings for product operation.
Configuration details for Ethernet and Wi-Fi network settings.
Instructions for powering the system on and off.
Configuring CONNECT-W with one wired network connection.
Configuring CONNECT-W with two wired network connections.
Setting up networks when the Wi-Fi access point is not enabled.
Linking CONNECT-W's embedded wireless network to Ethernet.
Steps to create a tightening unit and associate a tool.
How to run a Pset and view the tightening results.
Steps for creating a new assembly process.
Procedure for executing a configured assembly process.
How to view the results of an assembly process.
How to view and interpret tightening results.
Managing features: checking status and adding new ones.
Procedures for backing up data via USB and creating snapshots.
Detailed steps for the UV rebalancing process.
Verifying the successful transfer of UVs during rebalancing.
Instructions for managing UV counters within the system.
Details on UV assignment and requirements for features.
How to read UV graphs and check available UV amounts.
Procedure for rebalancing UVs (Unit Values) to the RIM.
Retrieving identification and characteristics of connected tools.
Accessing configuration details for a connected tool.
Monitoring tool counters and operating temperature.
Checking the calibration status of the tool.
Troubleshooting steps when a tightening unit is inactive.
Steps to take when the connection with the tool is lost.
General