3
7. Important!
Wait for “0.0 lb” to be displayed before stepping
on the scale . (figure 6)
8. Step on the scale and stand still, your weight measurement will be shown on the screen.
9. Step off the scale ,when “0.0 lb” appear you can measure again.
Note: The scale will turn off automatically after “0.0 lb” appear
10 seconds if you don’t step on the scale.
Now you are ready to go! Enjoy your scale!
1. Check the battery is correctly installed.
2. Check that you have selected your preference of lb/kg/st.
3. Check whether the scale is on a flat, level floor and not touching against a wall.
4. Do not step on scale until “0.0 lb” appears.
5. If, when you tap the scale to activate it, there
is no display at all or “Lo” is displayed- Try a
new battery (figure 7)
6. If “O-Ld” is displayed, the scale has been
overloaded. (figure 8)
If you experience any difficulty in use of the scale:
Advice for use & care:
fig6
fig7
fig8
Weight overload
Replace Batteries
1. The glass platform will be slippery when it is wet. Keep dry.
2. Keep standing still during the course of weighing.
3. Treat the scale with care as it is a precise instrument.
4. Clean the scale with a damp cloth and avoid water getting inside the scale. DO NOT use chemical/abrasive cleaning agents.
5. Keep the scale in cool place with dry air.
6. If scale fails to turn on, check whether battery is installed properly, or battery power is low. Insert or replace new battery.
7. If there is error on display or the scale will not turn off for a long period of time, please take out the battery for about
3 seconds, then install it again to correct error. If you cannot resolve the problem, please contact Detecto Customer
Service for consultation 800-336-5282.
8. Do not use for commercial purposes.
To Next Page
Loading...
Need help?
General
