What to do if the beam does not move at all during weighing on Detecto 337 Scales?
If the beam of your Detecto Scales doesn't move at all during weighing, it could be due to the small and large poise being set higher than the actual weight. Try resetting both poises to a lower or zero weight. Also, check that the draft rod is properly connected and aligned.
How to fix Detecto 337 Scales if the beam does not move freely?
If the beam of your Detecto Scales does not move freely, ensure the beam pointer isn't touching the side of the trig loop, which could impede its movement. Visually check that the linkage is centered and properly aligned, as misalignment can occur during shipping. The linkage must be free-floating for the scale to weigh correctly. If the scale is slightly tipped, inspect the linkage by looking underneath the weigh beam headpiece.
How to recalibrate Detecto 337 Scales?
To recalibrate your Detecto Scales, place a known weight on the scale and turn the balance screw until the pointer remains centered within the trig loop.
How to adjust zero balance on Detecto 337?
To adjust the zero balance on your Detecto Scales, balance the weighing beam so the beam pointer comes to rest in the center of the trig loop when both the small and large poise are set at zero (far-left position). Refer to Figure 9 and the BALANCING THE SCALE instructions.
Why does the platform rock excessively on my Detecto 337?
If the platform of your Detecto Scales rocks excessively, make sure the scale is on a level surface. When you push down on any corner of the platform, you shouldn't feel any significant rocking.
Legal notice regarding reproduction and patent liability for the manual's content.
Seller assumes no responsibility for errors or damages resulting from the use of manual information.
Essential safety instructions for patient supervision and control while using the scale.
To Next Page
General
