8525-0374-0M Rev A y Physician’s Scale Owner’s Manual
9
HAND POST INSTALLATION
For scale models that come with the hand post, please use the following instructions to
install the hand post to the scale platform.
1. Remove the four hex head screws and washers from the scale base and set them aside.
2. Place the hand post on the scale platform, aligning the holes in the hand post with the
holes in the scale platform, and then install and finger-tighten the four hex head screws
and washers to attach the hand post to the scale platform.
3. Using the provided wrench, tighten all four
hex head screws to secure the hand post
to the scale platform.
Figure 10. - Remove the four hex head
screws from scale platform
Figure 11. - Place hand post on scale
platform and install screws and washers
Figure 12. - Tighten all hex head screws
to secure hand post to scale platform
Figure 13. - View of scale with hand
post installed on scale platform
To Next Page
Loading...
Need help?
General
