Remote Control
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat,e.g. due to the total or partial obstruction of the grids. In
this case, unplug the appliance, wait about 30 minutes for it to cool down and remove the
object which is obstructing the grids. Then switch it back on as described above. The
appliance should operate normally. Should the problem persist, please contact the
nearest customer service.
NOTE: To assist in maintaining the internal components, after pressing the OFF button the fan
will continue to blow room air for a period of 15 seconds before shutting down to standby.
In the event of abnormal overheating, a safety device shuts down the appliance
automatically. In this case, must unplug the heater, after a short cooling down phase,
the appliance is ready for use again.
If you still notice the same defect as above mentioned, remove the plug from the
socket and consult your authorized dealer to your after-sales service department.
During use, do not touch or cover the air outlet. This may cause the unit to over heat,
and the safety device to operate.
The unit is also fitted with a tip over switch, it will cut out the power automatically if
tipped over.
To Next Page
Loading...