5
OPERATIONS
1. Open the cover and remove the ice cube basket. Then pour potable water into the water reservoir.
Keep the water below the water level mark.
2. Press the ON/OFF button on the control panel to turn on the unit to begin the ice cube making
process.
3. Select the size of the ice cube by pressing the SELECT button. Choose from small, medium or
large sze by cycling through the selection below:
If the room temperature is lower than 16°C, it is recommended to select small or medium-size ice
cubes to prevent them from sticking together.
4. The ice cube making cycle lasts between 6 and 13 minutes, depending on the size of the ice cube
selected and the ambient temperature. In extremely hot weather, ice cube making time may vary
quite considerably.
5. While the ice maker is on, check the water level periodically. If the water pump cannot inject water
into the ice maker, the ice maker will stop automatically and the ‘Add water’ symbol will flash in
the LCD display window. Fill up water to the water level mark and press the ON/OFF button 2 times
to turn on the unit. Allow the refrigerant liquid inside the compressor to settle for at least 3 mins
before restarting the ice cube making process.
6. The ice maker will stop automatically when the ice cube basket is full and the ‘Ice full’ symbol
displays in the LCD display window.
7. Change the water in the water reservoir every 24 hours to ensure a reasonable hygiene level. If the
unit is not in use, drain all remaining water in the reservoir.
∙ Timer delay time range: 0.5 to 19.5 hrs
∙ Default delay time: 3 hrs
When the unit is running, you can set the unit to stop running after a pre-set time with the OFF-TIMER.
And when the unit has stopped, you can also set the unit to start automatically after a pre-set time with
the ON-TIMER so that ice cubes are always ready for use when you are not around to make them.
To set the timer, press the TIMER button and the default time ‘3.0H’ will flash in the LCD display. Press
tthe SELECT button to select your desired delay time. Each press of the SELECT button will increase the
time delay interval by 0.5 hr. Press and hold the SELECT button for more than 3 secs and the delay time
interval will change quickly. When you have selected the delay time with no further changes to it for
5 secs, the timer program will be set.
To cancel the timer when the timer program has been set or during the time setting process, press the
TIMER button and the delay time digits will disappear. This indicates that the timer program has been
cancelled.
A. MAKING ICE CUBES
B. TIMER SETTING
To Next Page
Loading...
