Quick Reference
- 7 -
2—Loading paper and specialty media
Setting the paper size and type
1. From the printer control panel, navigate to:
>Settings > >Paper Menu > >Paper Size/Type >
2. Press the up or down arrow button to select the tray or feeder, and then press
.
3. Press the up or down arrow button to select the paper size, and then press
.
4. Press the up or down arrow button to select the paper type, and then press
to change the
settings.
Configuring Universal paper settings
The Universal paper size is a user-defined setting that lets you print on paper sizes that are not preset in
the printer menus.
Notes:
• The smallest supported Universal paper size is 76.2 x 127 mm (3 x 5 inches), and is supported only
from the multipurpose feeder.
• The largest supported Universal paper size is 215.9 x 355.6 mm (8.5 x 14 inches), and is supported
from all paper sources.
1. From the printer control panel, navigate to:
>Settings > >Paper Menu > >Universal Setup > >Units of Measure > >
select a unit of measure >
2. Select Portrait Width or Portrait Height, and then press
.
3. Press the left or right arrow button to change the setting, and then press
.
Loading trays
CAUTION—POTENTIAL INJURY: To reduce the risk of equipment instability, load each tray
separately. Keep all other trays closed until needed.
1. Pull out the tray completely.
Note: Do not remove trays while a job prints or while Busy appears on the printer display. Doing so
may cause a jam.
To Next Page
Loading...
