14 © 2012 Finishing Brands UK Ltd.
Parts Replacement/Maintenance
Chart 1 – Air Caps
NOTE: When removing air cap from retaining ring, don’t remove the Slip Ring (2) or Retaining Ring Seal (5) from
the Retaining Ring. Damage to the parts may occur. Slip ring and Retaining Ring seal are not available as
replacements. Simply wipe parts clean and reassemble with new or clean air cap.
Chart 2 – Fluid Nozzle Range & Fluid Needle
Chart 3 – Optional Fluid Nozzles & Fluid Needles
NOTE: When replacing the fluid nozzle or fluid needle, replace both at the same time. Torque to 9–11 Nm (80–100
ft-ins). Don’t over tighten the fluid nozzle. Use SN-28 10mm Spanner supplied with the gun and check with a torque
wrench.
RECOMMENDED INLET
PRESSURE
(bar)
To Next Page
Loading...
