Technical specifications
The Devine D-series amplifiers (D-200, D-400 and D-600) share almost the exact same electronic circuitry.
The differences in the series are usually the power ratings and the larger power capacity in in some of the
devices. As the technical details are nearly identical, the table below describes the specifications and values
for all amplifiers. Some values and descriptions may be identical for more than 1 amplifier. Please pay close
attention to the power amplifier you have purchased by comparing the type number shown on the front panel
of your amplifier with this technical detail scheme:
D-200 D-400 D-600
8 ohms stereo output (RMS) 2x 100 W 2x 200 W 2x 300 W
4 ohms stereo output (RMS) 2x 180 W 2x 360 W 2x 540 W
8 ohms bridge output (RMS) 1x 360 W 1x 720 W 1x 1080 W
Frequency response (+/-1.5 dB) 20 Hz – 20.000 Hz
Minimum channel impedance 4 ohms
Input sensitivity 1 V
Input impedance (balanced) 20 kOhms
Input impedance (unbalanced) 10 kOhms
SMPTE 0.05 %
S/N ratio (A-weighted) > 100 dBA
T.H.D. (Total Harmonic Distortion) 0.05 %
Damping factor @ 1 kHz – 8 ohms > 200
Slew rate 20 V/uS
Built-in protection measures Soft start, DC current, Short circuit, Limiter, Overheat
Cooling Temperature controlled fans, heat sinks, ventilation slots
Connections (input) Balanced XLR and 6.35 mm TRS jackplug, stereo inputs
Connections (outputs) 2x black speaker-lock for channel outputs
1x red speaker-lock output for Bridge mode
Input voltage 115/230 V AC, 50/60 Hz
Maximum power consumption 430 W 860 W 1700 W
Stand-by power consumption < 1W
Fuse T3.15 AL 250V F6 AL 250V F8 AL 250V
Net. weight 3.2 kg
Dimensions 483 x 160 x 44 mm
Dimensions (rack install) 19-inch, 1U
Included accessories:
- Power cable IEC C13 to Schuko (3x 1 mm²)
- Power cable IEC C13 to UK (3x 1 mm²)
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 4.0 Creation date + author initials: 11-12-2015 RV Revision date + author initials: 10-12-2015 RV
To Previous Page
Loading...