Initial use 19
devolo dLAN pro 1200+ PoE
Check whether the device is connected to the
mains supply correctly and whether the encryp-
tion process has been carried out successfully.
For more information about this, refer to 3.4
Connecting the dLAN pro 1200+ PoE.
쎲 The LED lights up white if the
dLAN pro 1200+ PoE is ready to operate and a
dLAN connection exists.
쎲 The LED flashes white quickly at regular inter-
vals if the encryption process (pairing) is being
performed in the dLAN pro network.
쎲 The LED flashes white at irregular intervals if
the dLAN pro 1200+ PoE is in PowerSave
mode.
쎲 The LED flashes red at regular intervals if the
transmission rate of the dLAN pro 1200+ PoE is
not in the optimum range. For information on
improving the transmission rate, refer to Chapter
5.1 Bandwidth optimization.
The function of the LED status display
can be disabled in
dLAN AVpro manager.
3.3.2 PoE button
This button controls the PoE functionality as
follows:
By default, PoE functionality of the
dLAN pro 1200+ PoE is enabled.
You can disable the PoE functionality of the
dLAN pro 1200+ PoE for 10 seconds to briefly dis-
connect the connected device from the mains supply
and restart it.
For more information on PoE functionality, re-
fer to Chapter 2.3.4 PoE operation.
Indicator light
The indicator light (LED) shows the status of PoE by il-
luminating and/or flashing in different ways:
쎲 The LED lights up white when PoE is enabled.
쎲 The LED is off during the 10-second deactivation
of PoE.
3.3.3 Reset button
The Reset button (next to the Ethernet jack) has the
following function:
쎲 To change the configuration of the
dLAN pro 1200+ PoE back to the factory
defaults, press the Reset button for more than
10 seconds. Keep in mind that all settings that
have already been configured will be lost!
To Next Page
Loading...
