Devolo Magic 2 LAN1-1 User Manual

Introduction 18
devolo Magic 2 LAN
1-1
* Information about the web interface can be
found in Chapter 4 Configuration.
** Information on improving the transmission rate
can be found in Chapter 5.2 Bandwidth optimi-
zation.
***A devolo Magic adapter switches to standby
mode after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface. In this mode, the devolo Magic
adapter cannot be accessed over the electrical wi-
ring. As soon as the network device (e.g. computer)
connected to the network interface is switched on
again, your devolo Magic adapter can also be ac-
cessed over the electrical wiring again.
Check whether the adapter is connected to
the mains supply correctly and whether the
pairing operation has been carried out suc-
cessfully. For more information about this,
refer to 3.3 Connecting the
devolo Magic 2 LAN
1-1
.
2.3.2Network connection
You can use the network connection on the
devolo Magic adapter to connect it to a PC or tele-
vision using a standard network cable.
2.3.3Integrated electrical socket
Always use the integrated electrical socket on the
devolo Magic adapter when connecting other
consumers to the mains supply. In particular,
electronic devices with mains adapter can negati-
vely affect PLC performance.
The integrated mains filter in the devolo Magic ad-
apter filters any such external interference and re-
duces any impairment of PLC performance.

Devolo Magic 2 LAN1-1 Specifications

General

Brand	Devolo
Model	Magic 2 LAN1-1
Category	Adapter
Language	English