Connection and installation
|
|
devolo MicroLink dLAN duo
|
12
EN
2.3 Connecting the MicroLink dLAN duo...
In this section, we will show you how to connect the MicroLink dLAN duo—
either via Ethernet or USB. If both are installed, USB has priority.
Before connecting the MicroLink dLAN duo please note its security ID and
keep it available for configuration of the network. The security ID can be
found on the bottom of the dLAN adapter.
2.3.1 ...via Ethernet
햲 With the computer running connect the MicroLink dLAN duo adapter to
an Ethernet port of the computer with the network cable (included).
햳 Plug the MicroLink dLAN duo adapter into a convenient power socket.
햴 Then install the devolo MicroLink dLAN Software. For more information
see the '
devolo MicroLink dLAN Software' chapter.
No drivers are required for installation of the MicroLink dLAN duo adapter.
2.3.2 ...via USB
햲 With the computer running connect the MicroLink dLAN duo adapter to a
USB port of the computer with the USB cable (included).
햳 Plug the MicroLink dLAN duo adapter into a convenient power socket.
햴 Now install the drivers in the desired operating system.
햵 Then install the devolo MicroLink dLAN Software. For more information
see the '
devolo MicroLink dLAN Software' chapter.
Driver installation...
The MicroLink dLAN duo supports plug&play. This makes installation much
easier. Windows wizards guide you through the installation process and
request the required data.
...under Windows 98
햲 Put the devolo product CD in your CD-ROM drive.
햳 Windows starts the hardware wizard and reports that new hardware has
been detected. Confirm by clicking Next.
To Next Page
Loading...
Need help?
General