Devon CircuFlow 5200 - Treatment Process; Prefilling and Treatment Cycle; Post-Treatment Vacuuming; Powering Off and Removal

www.devonmedicalproducts.com • 1100 First Avenue, Suite 202 King of Prussia, PA 19406 • 866.446.0092
The pump will go through its initial prefill stage of
reaching 10 mmHg in all 4 chambers.
Each treatment will end after its set treatment
time has elapsed. The user can also end the
treatment at any time during a treatment session
by pressing the STOP button on the front panel.
*Note: If the user presses STOP the treatment
will not pick up from where it left off at.
After the treatment, the device will vacuum air
from the garment for 1 minute so that it will facili-
tate removal of the garment. (Not Pictured)
*Note: If using one of the larger size sleeves all
the air may not vacuum out within 1 minute. The
vacuum setting can go through another 1
minute cycle by pressing STOP.
Once the sleeve is deflated, press the power
switch on the backboard to the OFF position and
then unplug the power cord.
Once the power indicator light is off, it is safe to
remove the garment. (Not Pictured)
The garment should be loose enough now that
you can unzip the garment and remove.
(Not Pictured)
13
56
57
58
59
60
61
TREATMENT
56
57
59