DeWalt D28112 - Accessory Mounting and Gear Case; Mounting Grinding and Wire Wheels; Rotating the Gear Case

English
9
ATTACHING SIDE HANDLE (FIG. 2)
The side handle (E) can be fitted to either
E
FIG. 2
side of the gear case in the threaded
holes, as shown. Before using the tool,
check that the handle is tightened se cure-
ly. Use a wrench to firmly tighten the side
handle.
Rotating the Gear Case (Fig. 3)
1. Remove guard and flanges from tool.
2. Remove the four corner screws attaching the gear case to motor
housing.
3. Separating the gear case from motor housing not more than 1/4"
(6.35mm) rotate the gear case head to desired position.
NOTE: If the gear case and motor housing
90˚
90˚
FIG. 3
become separated by more than 1/4"
(6.35mm), the tool must be serviced and
re-assembled by a D
EWALT service center.
Failure to have the tool serviced may cause
brush, motor and bearing failure.
Type 27 guard
4-1/2" (114.3mm) Grinding Wheels
backing flange
threaded clamp nut
Type 27 hubbed wheel
Type 27 guard
Type 27 depressed
center wheel
Wire Wheels
3" (76.2mm)
wire cup brush
4" (101.6mm)
wire wheel
Type 27 guard
Type 27 guard